Design:

The selection of the correct pole design is predicated on the specific loading requirements of each application. The poles located in the steel pole chart are designed to withstand dead loads and theoretical dynamic loads developed by sustained winds of 80 MPH through 110 MPH times the 1.3 gust factor. The combined EPA and the weight of the luminaire, light support brackets, platforms and any other attachments cannot exceed the rated EPA or allowable weight of that pole.

Welding:

All welds shall be of the highest quality and performed by American Welding Society certified welders conforming to the latest version of the American Welding Society specification AWS D1.1.

Finish:

All poles, mounting brackets and platforms are furnished with a coating of either red oxide/zinc primer, factory painted, powder coated or hot-dip galvanized to ASTM A-123. Miscellaneous hardware will be galvanized to ASTM A-153. Exterior finish coatings are available by request.

Pole Shaft:

The steel pole shall consist of the appropriate number of pole sections, either round or multi-sided, for heights up to 120 feet. Each section shall be fabricated from high strength low alloy steel conforming to ASTM A-572, with a minimum yield strength of 55,000 psi. These shafts shall telescope over each other to match the overall desired pole height. The overlap telescoping joint shall have a length that is the larger of 2 feet or 1-1/2 times the diameter of the inside of the female tube. The sections shall be pre-fitted and match marked at the factory. All sections shall maintain a uniform taper from top to bottom. There shall be at least one longitudinal seam weld in the tapered section of the shaft. The longitudinal seam weld shall have at least 60% penetration, except in the areas where the shaft section telescopes over another. In overlapping areas, the weld penetration shall be 100%. No circumferential weld splices may be used in fabricating the shafts.

Hand Hole:

An oval reinforced hand hole, having a nominal 4” x 6” x .25” wall, will be installed 18” above the groundline. A hand hole cover and attaching hardware is included with each hand hole assembly. A ground lug will be welded inside the pole opposite the hand hole. This is standard on all poles unless otherwise specified.

Embedment:

The embedded portion of the pole which will be 10% of the free pole height + 2 feet, will include two 3” x 5” reinforced hand holes at 180 degrees apart, 24” below ground level for wire access. A 1/4” thick bearing plate will be integrally welded to the base of the shaft to aid in anti-rotation.

As an option, a mastic coating may be applied at the ground level of the outer pole shaft +/- one foot to serve as added protection against the elements.

Pole Tops:

Each pole will be provided with either a removable pole cap, fl at plate, or 2 3/8” O.D. x 5” tenon top (other sizes available).

See Spec Sheet